Yamaha CRW4416S - Manual (Page 12)

Chapter 2 - Installing the Yamaha CRW4416S Drive
6
Note: When you are using Windows 95 or Windows 98, and if the SCSI ID set-
ting on the rear panel is the same as the number assigned to another
SCSI device, the Plug and Play component of Windows 95 or Windows
98 will automatically assign an unused number to the CRW4416S
(SCAM protocol level 1).
■ Parity setting
Parity ON (with a jumper)
— Parity Check will be performed. Normally, use this setting.
Parity OFF (without a jumper)
— Parity Check will not be performed.
1 2 4
SCSI ID 1
1 2 4
SCSI ID 2
1 2 4
SCSI ID 3
1 2 4
SCSI ID 4
1 2 4
SCSI ID 5
1 2 4
SCSI ID 6
1 2 4
SCSI ID 7
1 2 4
SCSI ID 0
SCSI ID Setting
* Use jumper connectors to short the locations shown in black.
1 2 4
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
Parity ON (default) Parity OFF
* Use jumper connectors to short the locations shown in black.