Chapter 2 - installing the yamaha crw4416s drive, Crw4416s drive settings – Yamaha CRW4416S User Manual

Page 11

Chapter 2 - Installing the Yamaha CRW4416S Drive

CRW4416S drive settings

Before installing the CRW4416S in your computer, you will need to set

the following jumpers.

• SCSI ID settings

• Parity setting

• Terminator setting

• Block size setting

This setting is set by inserting a jumper pin in the jumper switch

located on the rear panel of the CRW4416S drive.

Important:

Use long-nose pliers to remove or insert jumper connectors.

In the diagrams in this manual, solid black fill is used to indicate loca-

tions where a jumper is used to short between pins.

Rear Panel

■

SCSI ID settings

The SCSI ID number is used so that the computer will recognize a con-

nected SCSI device. You can assign 0 through 7 as the SCSI ID number.

Usually, “7” is reserved for the SCSI card ID number, and “0” is

reserved for the first SCSI device in the chain.

Use a number between 1 and 6 for the CRW4416S. Refer to the diagram

below for more information on setting the SCSI ID number. The factory

set ID number is “3”.

Important:

If you are using other SCSI devices, be sure to use a unique ID number

for each device.

AUDIO OUT

R G L

ID SELECT
PARITY

TERMINATOR

BLOCK SIZE

1 2 4

SCSI
INTERFACE
CONNECTOR DC INPUT

12V

Jumper Switch