Yamaha Professional Audio Workstation AW4416 - Manual (Page 135)

Chapter6—Transport/locate operations
120
— Operation Guide
In/out points
The AW4416 remembers the locations at which recording was last begun and
ended as the In point and the Out point. When the In and Out points are memo-
rized, the [IN] and [OUT] keys will light. In this state, you can press the [IN] key
or the [OUT] key to locate to the In or Out points. You can also set the In or Out
points manually.
❒ Setting the In point/Out point
1. Locate the song to the location where you wish to set the In point.
2. Hold down the Locate section [SET] key and press the [IN] key.
3. Locate the song to the location where you wish to set the Out point.
4. Hold down the [SET] key and press the [OUT] key.
The In point and Out point that you specify will be displayed as follows in the
TRACK screen TR View page that appears when you press the [TRACK] key →
[F1] key.
Tip!
• The In/Out points are also used as the auto punch-in/out points used by auto
punch-in/out (→ P.130).
• The In/Out point settings are saved on the hard disk as part of the currently
selected song.
You must set the In point ahead of the Out point.
LAST REC
MARK SEARCH
LAST REC
5 4
IN OUT
NO
A B REPEAT
RTZ
2 3 1
0
ROLL
BACK
CANCEL
SET
MARK
NUM
LOCATE
8 9 7
6
AUTO
PUNCH
LAST REC
MARK SEARCH
LAST REC
5 4
IN OUT
NO
A B REPEAT
RTZ
2 3 1
0
ROLL
BACK
CANCEL
SET
MARK
NUM
LOCATE
8 9 7
6
AUTO
PUNCH
In point Out point