Williams Sound Transmitter T36 - Manual (Page 13)

11
H e l p i n g P e o p l e H e a r
10
H e l p i n g P e o p l e H e a r
BATTERY INFORMATION
Open the battery compartment by pressing and lifting the tab on the back of the device with your
finger. To remove depleted batteries, pull up on the fabric strip. Press the new batteries into place
over the fabric strip. Be sure to observe proper polarity (+/-). Damage due to improper battery instal-
lation may void the warranty on the product. Close the battery door. The “Power On” LED on top of
the device will flash when the batteries are getting low; you may continue to use the unit until it stops
operating, then replace or recharge batteries.
The receiver or transmitter can use two (2) Alkaline AA batteries (BAT 001) or two (2) AA recharge-
able batteries (BAT 026). Note: The BAT 026 provides longer life than other rechargeable batteries.
For best product performance, do not substitute other rechargeable batteries and chargers.
R33/R36 EXPECTED BATTERY LIFE
Alkaline batteries
(BAT 001): 21 hours
Rechargeable NiMH Batteries
(BAT 026): 17 hours
Minimum14 hour recharge time.
If the Motiva™ System you’ve purchased is equipped with rechargeable batteries, up to 2 units can be
charged with the CHG 3502 that comes with the system. Up to 12 units can be charged at one time
in the optional CHG 3512 or CHG 3512 PRO multi-charger. For ordering information, please contact
Williams Sound at 800-843-3544. Additional information on the CHG 3502 is listed below.
T36 EXPECTED BATTERY LIFE
Alkaline batteries
(BAT 001): 30 hours
Rechargeable NiMH Batteries
(BAT 026): 20 hours
Minimum14 hour recharge time.
AC Power Connection CHG 3502
Rear View
Charging
LED Indicator
Receiver or
Transmitter
WARNING: Use this charger with Williams Sound NiMH rechargeable batteries only. DO NOT
use non-rechargeable batteries, such as alkaline and carbon zinc, which may heat up and burst,
causing possible injury and damage to the equipment.
Before inserting the receiver or transmitter into the charger, be sure each unit has NiMH rechargeable
batteries installed. Also, check to make sure the switch setting in the receiver or transmitter battery
compartment indicates the “NiMH” setting.
1. Plug the CHG 3502 power supply into the
AC wall outlet. Plug the power connector into
the rear of the CHG 3502 unit (FIG. 10B).
2. Insert the receiver or transmitter into the
charging slot as illustrated in FIG. 10A. The
unit(s) must be placed in the charger facing
forward to make contact with charger con-
tacts. A red LED indicator will illuminate when
the batteries are being charged (FIG 10A.).
• You may charge up to 2 receiver /
transmitter units per CHG 3502 charger.
• It will take approximately 16 hours to fully
charge the batteries.
NOTE: It is safe to leave the receiver/trans-
mitter units in the charger, even after the
batteries are fully charged.
FIG. 10A
FIG. 10B
Refer to
page 6 for
battery life
expectancy
after low
battery
signal.