Yamaha DVD-S700 - Manual (Page 42)

42
A
B
C
Disc handling and maintenance
Handling precautions
Á
Hold the disc by the edges so the surface will not be soiled
with fingerprints. (
) )
Fingerprints, dirt and scratches can cause skipping and dis-
tortion.
Á Do not write on the label side with a ball-point pen or other
writing utensils.
Á
Do not use record cleaning sprays, benzine, thinner, static
electricity prevention liquids or any other solvent.
Á Be careful not to drop or bend the disc.
Á Do not install more than 1 disc on the disc tray.
Á Do not try to close the disc tray when the disc is not in-
stalled properly. (
* )
Á Be sure to store the disc in its exclusive case when not in
use.
If the surface is soiled +
Wipe gently with a soft, damp (water only) cloth.
When wiping discs, always move the cloth from the center
hole toward the outer edge.
(If you wipe the discs using a circular motion, circular scratch-
es are likely to occur, which will cause noise.)
If the disc is brought from a cold to a warm en-
vironment, moisture may form on the disc
Wipe this moisture off with a soft, dry, lint-free cloth before
using the disc.
Improper disc storage
You can damage discs if you store them in the following
places:
Á Areas exposed to direct sunlight
Á Humid or dusty areas
Á Areas directly exposed to a heat outlet or heating appliance
Discs which cannot be played with this player
For Continental Europe and United Kingdom models
Á
DVD with Region No. other than “2” or “ALL”
For Australia model
Á DVD with Region No. other than “4” or “ALL”
For other models
Á DVD with Region No. other than “3” or “ALL”
Á DVD-ROM
Á DVD-R/DVD-RAM
Á CD-ROM
Á
CDV
Á CD-G
Á Do not try to play Photo CD or CD-R.
To prevent a malfunction of this unit
Á Do not use any non standard shaped CD (heart etc.) avail-
able on the market, because it may damage the unit.
Á Do not use a CD with tape, seals, or paste on it, because
damage to the unit may result.
Maintenance
Á Be sure to switch the power to the standby mode and dis-
connect the AC mains lead before maintaining the unit.
Á Wipe this unit with a dry soft cloth.
If the surfaces are extremely dirty, wipe clean with a cloth
which has been dipped in a weak soap-and-water solution
and wrung out thoroughly, and then wipe again with a dry
cloth.
Á Never use alcohol, benzine, thinner, cleaning fluid or other
chemicals. And do not use compressed air to remove dust.
Disc tray
Disc