Yamaha DVD-S700 - Manual (Page 37)

37
POWER
@ STOP
TITLE
SUBTITLE
MARKER
ANGLE AUDIO
ON SCREEN RETURN
MENU
SELECT
H SKIP I F G
D PLAY g STILL/PAUSE
OPEN/CLOSE
* / I
PLAY MODE
REPEAT
A-B CLEAR
DVD
SET UP
SLOW/
SEARCH
1
3
~
SELECT
Initial settings
Selecting digital output
Select the digital output to be output from the optical/coaxial
digital audio output connector of the unit.
1
At the initial settings screen
Press
)
/
*
to select “7 Digital Audio Out-
put” and press SELECT.
2
Press
)
/
*
to select the preferred item
(1–3) and press SELECT.
When “1 LPCM (DVD)” is selected
Off:
Only linear PCM of 48 kHz/16 bit is output from
the digital audio output connector. During play-
back of the DVD recorded in the linear PCM of
48 kHz/20 bit/24 bit or 96 kHz, no digital audio is
output. (Factory setting)
PCM: During playback of the DVD recorded in the linear
PCM of 48 kHz/20 bit/24 bit or 96 kHz, digital au-
dio converted to 48 kHz/16 bit is output.
(Digital output of PCM audio is restricted to
48 kHz/16 bit or below for copyright protection.)
When “2 Dolby Digital” is selected
Bitstream: Dolby Digital (AC-3) bitstream (2ch–5.1ch)
is output. (Factory setting)
PCM: PCM (2ch) of 48 kHz/16 bit is output.
When “3 MPEG” is selected
PCM:
PCM of 16 bit is output. (Factory setting)
Bitstream: Bitstream is output.
3
Press
)
/
*
to select the preferred value at
each screen and press SELECT.
The screen at the step 1 is displayed. Press * to select “0”
and press SELECT to return to the initial settings screen.
Also refer to “Common procedures of initial settings” on
page 31.
(Continued on the next page)
Digital Audio Output
1 LPCM (DVD)
2 Dolby Digital
3 MPEG
0 Exit
Off
Bitstream
PCM