NDC comm Instant Wave - Manual (Page 18)

AP COMFig Tool
The AP COMFig Tool is a Windows 95/98/ME/NT/2000 based utility that is used
via a COM port connection between the AP and a PC.
It provides the following functions:
• Sets necessary AP parameters (e.g., IP address, Domain name, etc.)
• Diagnoses the AP hardware and shows the diagnostic results
• Upgrades the AP firmware
• Resets the AP Configuration
• Manages the APMS Host table
Click Start/Programs/Wireless LAN AP SB/AP COMFig Tool to start the
program. The program opens with the AP COMFig Tool Connect screen. Then
follow the steps below to begin using the AP COMFig Tool.
step1. Connect the null modem cable to the serial port on the AP and connect
the other end to a serial port on the PC
step2. Select the COM port
step3. Power on the AP. The AP COMFig Tool will connect with the AP
automatically
Note: You have to go through the steps above each time you want to use the AP
COMFig Tool.
Using the AP COMFig Tool
AP COMFig Password
Click on the Password tab to open the Password screen. Here you may set a
password if so desired. Setting a password prevents unauthorized changes to the
AP configuration settings.
Note: The password will be shared with the APMS program on the same PC.
12 InstantWave High Rate Access Point