Printek 4503 - Manual (Page 57)

Epson FX Emulation
Page 3-29
Emulations
Select Software Interface n ESC ESC n
Selects the software interface n according to the table below.
n Software Interface
0 Test (reserved for factory use)
1 ANSI X3.64 Emulation
2 Epson FX Emulation
3 Bar Code Mode (optional)
4 IBM Proprinter Emulation
5 DEC LA120 Emulation
6 TTY Emulation
7 Printek Emulation
? Previously Selected Emulation
@ Default Emulation
Overrides the "Mode:" value in the "Setup: INTERFACE" menu. "Mode:
BarberPole" and "Mode: Hex Dump" cannot be overridden.
A numeric value for n may be specified in two different ways, with equivalent results:
a single byte with a value of 00 to 07 hex, or a single printable ASCII character "0" to
"7" (30 to 37 hex).
If more than one emulation has been selected, ESC ESC ? will return to the
previously selected emulation. This is particularly useful when the previous
emulation is unknown. Please beware that the memory (stack) is only one level deep.
ESC ESC @ will return to the default emulation, as specified by the "Mode:" value in
the "Setup: INTERFACE" menu.
This chapter describes Epson FX emulation. If a different interface is selected, the
control codes and escape sequences described in this chapter will no longer be
applicable.
Example: The following escape sequences will select Printek emulation, load form
one, and then return to the previous emulation.
Escape Sequence: ESC ESC 7 ESC L 1 ESC ESC ?
Hexadecimal: 1B 1B 07 1B 4C 01 1B 1B 3F