P3 International E 9300 User Manual
Page 10
10
In configuration mode the keys have the following functions:
IN
→
not used
SENSOR
→
EXIT
Leave configuration mode
MIN/MAX
→
+
Increase value
RAIN
→
–
Decrease value
OUT
→
NEXT
To the next setting
This key assignment is also shown on the rear of the weather station.
Please note!
If you press and hold down the "+" or "-" keys during the individual setting opera-
tions, the figures will run through more quickly.
After every setting operation you can either leave configuration mode by pressing
the "EXIT" key or proceed to the next setting via the "NEXT" key.
Configuration is performed in this order:
→
Year
→
Month
→
Date
→
Minutes
→
Hours
→
Daylight saving time
→
Deg. latitude (LA)
→
Deg. longitude (LO)
→
Time zone (ti)
→
Rain sensor
calibration
→
Rain quantity unit
→
Assignment of indicator path
→
Wind unit
Calling up configuration mode
Configuration mode is called up by pressing
the "IN" key for about 2 seconds. When the
key is released the corresponding display is
shown.
You can leave configuration mode at any time
as described in "Leaving configuration
mode".
Setting the date and time
Set the current year using the "+" and "-" keys.
Press "NEXT" to go to the month setting.
Set the month using the "+" and "-" keys.
Press "NEXT" to go to the date setting.
IN
[2 seconds]
+
Year
–
NEXT
+
Month
–
NEXT