Piaggio 250 i.e. - Manual (Page 21)

IF OWNERSHIP OF THE VEHICLE IS TRANSFERRED, THE RED-HANDGRIP KEY
(AS WELL AS THE OTHER KEYS) AND THE "CODE CARD" MUST ALSO BE TRANS-
FERRED TO THE NEW OWNER.
Programming the immobilizer system
Below is described the procedure to follow for programming the PIAGGIO IMMOBILIZ-
ER system and/or for storing other key codes. The programming procedure should be
carried out with the engine stop switch set to «RUN».
Procedure start - red key
Insert the red-handgrip key in the switch key (in "OFF" position) and turn it to "ON". After
1 - 3 seconds, turn the key to "OFF" again and pull it out.
Intermediate step - black key
After pulling out the red key, insert the black key within 10 seconds and promptly turn it
to «ON». After 1-3 seconds, turn the key to "OFF" again and pull it out. In this way, a
maximum of 7 black keys can be programmed by repeating the above procedure keeping
the indicated times.
Final step - red key
After pulling out the last black key, insert the red key again and turn it to "ON" (this oper-
ation should be performed within 10 seconds of pulling out the previous key). Leave it in
this position for 1 to 3 seconds and return it to the «OFF» position.
21
1 Vehicle