Panasonic DMR-ES20DEB - Manual (Page 54)

Before requesting service
FUNCTION
PICTURE
SOUND
10
46
53
88
17
No function possible.
The unit is switched on but cannot
be used.
The error code « H », «U »
or «F » appears:
The unit automatically switches to
standby mode.
No picture.
Television reception worsens when
the unit is connected.
The picture is not set correctly.
The picture flickers.
No on-screen messages.
î Check the power supply connection.
î One of the unit's security devices may have been activated.
Press /I to switch the unit on.
î Check the connection to the television set, e.g. AV1.
î When Encrypted is shown, you cannot view because the unit is
for viewing and recording free to view channels only.
î Check the aerial connection. You may need to use a signal amplifier.
î Adjust the picture. Read the operating instructions for the television.
î There is a malfunction. The numbers following the letter «H» indicate the
condition of the unit.
! Switch the unit to standby /I. If the unit does not switch to standby
mode, press and hold /I for approx. 10 seconds or unplug it from the
power supply for approx. one minute and reconnect the cable.
! Press /I to switch the unit on.
If the malfunction is not eliminated after this, contact customer service
and provide the code that is displayed.
No sound/
Volume set to quiet/
Distorted sound.
It is not possible to hear the desired
sound type.
The sound cannot be set for stereo or
NICAM broadcasts.
î Check the connections.
î If you have connected an amplifier, check its input mode.
î Switch off the V.S.S. function if it causes problems.
î Press DISPLAY and select [audio channel], to change to the desired
sound type.
î Change the appropriate setting in the Sound SETUP menu.
î Connect external devices with audio cables even if you use a digital
connection.
î You cannot change the sound type when using DVD-R/-RW(V)/+R.
î Change the [On-Screen Messages] setting in the Display SETUP menu.
î Check the [TV Aspect] setting in the Connection SETUP menu.
STROM DISPLAY
46
47
The display lighting
is weak.
"0:00" blinks on the unit display.
î Change the [FL Display] in the Display SETUP menu.
î No time. Set the time in the Others, [Clock] SETUP menu.
46
REMOTE CONTROL
7
No functions.
The television cannot be operated.
î If the unit is in TIMER standby mode ( on the unit) end this with TIMER.
î A wrong remote control code was selected.
î Check the batteries.
Point the remote control at sensor on the unit.
î The child lock feature has been activated.
î If the unit is in External Link Standby Mode (External Link is displayed on
the unit) end this by pressing EXT LINK on the remote control.
î A wrong remote control code was selected.
54