Linksys SLM224G4S - Manual (Page 39)

Chapter Configuration Using the Web-based Utility
24/48-Port 10/100 + 4-Port Gigabit Resilient Clustering Smart Switch with 2 Combo SFPs
QoS > Queue Settings
The Queue Settings screen is used to define the QoS queue
forwarding types.
QoS > Queue Settings
Strict Priority Indicates that traffic scheduling for the
selected queue is based strictly on the queue priority.
WRR Indicates that traffic scheduling for the selected
queue is based strictly on the WRR.
Queue Displays the queue (1-4) for which the queue
settings are displayed.
WRR Weight Displays the WRR weights to queues.
% of WRR Bandwidth Displays the percentage of
bandwidth assigned to the queue. These values are fixed
and cannot be modified.
Click Save Settings to save the changes, or Cancel
Changes to cancel the changes.
QoS > DSCP Settings
QoS > DSCP Settings
The DSCP Settings screen allows you to map Differentiated
Services Code Point (DSCP) values to specific queues.
DSCP Indicates the DSCP value in the incoming packet.
Select a DSCP value from the drop-down menu to map
that value to the associated queue. You can select the
DSCP value for the High, Medium, and Normal priority
queues. The DSCP values for the Low priority queue are
selected automatically based on the other DSCP values.
Queue The queue (1-4) to which the DSCP value is being
mapped.
Click Save Settings to save the changes, or Cancel
Changes to cancel the changes.
QoS > Bandwidth
QoS > Bandwidth
The Bandwidth screen allows network managers to define
the bandwidth settings for a specified egress or ingress
interface. Modifying queue scheduling affects the queue
settings globally. The Bandwidth screen is not used with
the Service mode, as bandwidth settings are based on
services.
Queue shaping can be based per queue and/or per
interface. Shaping is determined by the lower specified
value. The queue shaping type is selected in the Bandwidth
screen.
Interface The interface for which the queue shaping
information is displayed. Either select Unit No and select
the unit number and port from the drop-down menus,
or select LAG and select the LAG number from the drop-
down menu.
Enable Ingress Rate Limit Status Indicates if rate limiting
is defined on the interface.
Enable Egress Shaping Rate Indicates if rate limiting is
enabled on the interface.