Kohler ODEON VITREOUS CHINA P/S-TRAP TOILET K-8741T - Manual (Page 2)

1. REMOVE EXISTING TOILET
Turn off water supply. flush the toilet and use a sponge to
remove the remaining water from the tank and bowl.
Disconnect the supply shut-off valve (if present) and remove
the old tank and bowl. 1.
( )
TOOLS AND MATERIALS REQUIRED
(Not supplied)
·
·
·
·
·
·
·
·
·
·
·
254mm adjustable wrench
Metal file (file cut)
Tape measure
Tubing cutter
Level
Hacksaw
Putty knife
Screwdriver
Straight pipe coupling
Connection packing
Toilet supply shut-off valve, 10mm (3/8") recommended
The fill valve
nut has been factory-tightened, wrench tighten 1/4 turn
past finger tight.
If no shut-off valve exists, install a shut-off valve
below the tank before installing the new toilet.
Flexible hose are recommended to connect the supply line to
the fill valve. If you use a rigid connection, take care not to
apply side forces to the bottom of the fill valve.
WARNING: Risk of external leakage.
NOTICE:
( )
·
·
·
·
·
·
·
·
·
·
·
254mm
10mm(3/8")
1/4
ROUGHING-IN
-2-
698
337
267362 166 158
429
390
204
777 10
388
90 396
178
159
102
P-trap 8711T
204
776 10
392
93 474
305
102
20
S-trap 8753T
204
785 10
394
95 484
255
100
25
S-trap 8766T
Fig.#1
1
699
337
265362 158 156
428
390
INSTALLATION
736
344
259
363 162 155
433
390
1037406-T01-A
Unit:mm
: