Kenwood DDX8024BT - Manual (Page 74)

74 DNX9240BT/DDX8024BT/DDX8054BT
Crossover Network Setup
You can set a crossover frequency of speakers.
Select the speaker to set the crossover 1
2 2 2
1 1 1
3 3 3
4 4 4
1 Sets the High Pass Filter of the center
speaker.
2 Sets the High Pass Filter of the front speaker.
3 Sets the High Pass Filter of the rear speaker.
4 Sets the Low Pass Filter of the sub woofer.
Display the Crossover setup screen 2
Set the crossover 3
[Phase] Sets the phase of subwoofer output.
The phase is reversed 180 degrees when set
to "Reverse".
Sets the sub woofer phase. (Only when
"Subwoofer" is set to "ON" in Audio Setup)
[HPF FREQ] High Pass Filter adjustment.
(When front, center or rear speaker is selected
on Speaker Select screen)
[LPF FREQ] Low Pass Filter adjustment. (When
Subwoofer is selected on Speaker Select
screen)
[Slope] Sets a crossover slope.
Car Type (DTA) Setup
You can setup the car type and speaker network,
etc.
Display the Car Type Setup screen 1
Touch [ ] > [ ] > [Audio SETUP] > [Car
Type]. (page 59)
Setup the Car Type 2
If your car type is selected, the Digital Time
Alignment and Equalizer is set automatically (for
timing adjustment of sound output for each
channel) to have the highest surround effects.
1 1 1
1 Sets up the car type you use together with
this unit.
You can choose according to type of your car.
"OFF", "Compact", "Sedan", "Wagon", "Minivan",
"SUV", "Passenger van"
[Location] Sets the locations of the speakers.
[Adjust] Displays the Car Type Adjust screen.
You can adjust the digital time alignment that
was set automatically when you selected the
car type.
Setup Menu