Sony DFS-700 - Manual (Page 112)

Chapter 4 Advanced Operations
4-22
Chapter 4 Advanced Operations
Recalling a Snapshot
To recall a snapshot, use the following procedure.
1
To leave the primary cross-point bus section settings unaltered, press
the HOLD INPUT button, turning it on.
2
Press the RECALL button.
The button lights, and the pattern/numeric keypad is ready to accept a
snapshot number.
3
With the buttons 0 to 9, enter the snapshot number you want to recall.
You can use the UP and DOWN buttons to adjust the number
displayed.
4
Press the ENTER button.
This recalls the specified snapshot, and the control panel settings all
change correspondingly.
If, however, you turned the HOLD INPUT button on in step
1 , the
settings of the primary cross-point bus section do not change.
Direct Snapshot Recall
You can recall snapshots 0 to 9 with a single button operation.
Snapshots
LAST X
INS
RST
TITLE 1 2
EDITOR LUM LUM LUM
DSK EDGE
TRAIL
SHADOW
GPI CRK CRK BORDER BEVELD EDGE
SET UP MASK MASK MASK SOFT
SHIFT CCR LIGHTING BORDER MATTES LOCATION
LEARN EDIT
RECALL
HOLD
INPUT
INITIAL
PATTERN ADJ PAGE F1 F2 F3 F4 F5
USER PGM
STATUS EDIT
SNAP SHOT
SET
PATTERN NUMBER
EFFECT
DSK
FTB SET
TRANS RATE
7 8 9
4 5 6
1 2 3
0 DOWN UP ENTER
FADE
TO BLACK
P IN P DSK
DEL
N/R REV DSK PVW DIRECT
RECALL DIRECT PATTERN
CCR TITLE 1
SOURCE
TITLE 2
SOURCE
DSK
FILL SUPER BG FRGD 2 MEMORY FRAME FREEZ MIX EFFECT
BACKGROUND
BLACK MEMORY INT
VIDEO
TITLE 1 2 3 4 5 6 7 8
CUT
AUTO
TRANS
AUXILIARY
BLACK MEMORY INT
VIDEO 1 2 3 4 5 6 7 8
FOREGROUND
BLACK MEMORY INT
VIDEO 1 2 3 4 5 6 7 8
PATTERN/KEY PAD
1
2
3
4
SNAP SHOT number display