Shure Four Channel Automatic Microphone SCM410 - Manual (Page 5)

5
INSTALLATION
SUPPLIED HARDWARE
• 4 rubber feet
• 1 rackmount bracket, long
• 1 rackmount bracket, short
• 2 straddle brackets • 10 bracket screws, 6 mm (1/4 in.)
• 4 rackmount screws, 2.54 cm (1 in.)
• 4 plastic washers
• 4 wood screws, 1.25 cm (1/2 in.)
RACK MOUNTING
The SCM410 is supplied with hardware for mounting one or two units
to a 19-inch audio equipment rack. The hardware can also be used to
rack mount other Shure products, including the SCM268, SCM262,
DFR11EQ, and the DP11EQ.
Single Mixer (Half Rack) Installation
1. Attach the short and long rackmount brackets to the SCM410/E
with eight (8) of the supplied bracket screws.
2. Place the mixer in an equipment rack and secure it with the
supplied rackmount screws and plastic washers.
Dual Mixer (Full Rack) Installation
1. Place the two mixers side-by-side and connect them with two (2)
straddle brackets. The brackets should straddle the recessed
edges on the top and bottom of each mixer.
2. Fasten the straddle brackets using eight (8) bracket screws.
3. Attach the short rackmount brackets to the outsides of the com-
bined mixers with eight (8) of the bracket screws.
4. Place the mixer in an equipment rack, using the supplied rack-
mount screws and plastic washers.
INSTALLING HALF-RACK MOUNTING BRACKETS
RACK MOUNTING A SINGLE SCM410/E MIXER
INSTALLING STRADDLE BRACKETS
INSTALLING FULL-RACK MOUNTING
BRACKETS
RACK MOUNTING DUAL SCM410/E MIXERS