Shure Four Channel Automatic Microphone SCM410 User Manual
Page 4
4
REAR PANEL
ᕡ Power Connector: Unit is energized when the power cord is
plugged into a 100-120 Vac (SCM410) or 220-240 Vac
(SCM410E) power source. NOTE: There is no power On/Off
switch on this mixer.
ᕢ DIP Switch: The 4-position DIP switch provides additional func-
tions. Refer to the “DIP Switch Functions”section.
ᕣ Microphone Logic Connector: High density DB-15 male con-
nector provides connection to GATE OUT, MUTE IN, and
OVERRIDE IN logic terminals on each channel. Refer to the
“Advanced Functions” section. NOTE: THIS IS NOT A VGA
MONITOR PORT.
ᕤ AUX OUT Phono Connector: Feeds consumer-level audio
equipment, such as a tape recorder, VCR, or video camera. Not
affected by MIC/LINE switch.
ᕥ MIC/LINE XLR OUTPUT Connector: Can be set for micro-
phone or line-level output via a DIP switch.
ᕦ LINK IN/OUT Connector: Permits multiple SCM410/E, FP410,
SCM810, SCM800, or AMS8100 mixers to be linked, creating
additional inputs.
ᕧ MIC LEVEL XLR INPUT Connectors: Active balanced micro-
phone-level XLR inputs. For instructions on how to modify the
level of these inputs, refer to the “Internal Modifications” section.
DIP SWITCH FUNCTIONS
The rear panel DIP switches, shown in Figure 1, provide the functions
listed in the table below.
*Factory setting.
Last Mic Lock-On: Keeps the most recently activated microphone
turned on until another microphone is activated. When defeated, mi-
crophones turn off after their default hold time.
XLR Output Level: Sets the level of the XLR output to line or micro-
phone level. Make sure the output level matches the input level of the
device connected to the SCM410.
NOTE: The output level does not affect the auxiliary output
(AUX OUT) level.
Limiter: Activates the output limiter and sets it to a default threshold of
+16 dBu (see Internal Modifications for other threshold settings).
12V Phantom Power: When this switch is in the ON position, the
SCM410 provides 12Vdc phantom power to each XLR microphone in-
put. This function is particularly useful when using condenser micro-
phones, since most condenser microphones require phantom power.
NOTE: Phantom power does not affect the operation of
balanced dynamic microphones. They can be connected to the
SCM410 in combination with condenser microphones that use
phantom power. For instructions on how to disable phantom
power by channel, refer to the “Internal Modifications” section.
2
3
4
5
6
7
1
Last Mic
Lock-On
XLR
Output
Level
Limiter
12V
Phantom
Power
Switch
Number
1
2
3
4
Switch Up All mics off
after hold time
Mic Level
ON
ON
Switch
Down
ON*
Line Level* OFF*
OFF*
1 2 3 4
DIP SWITCHES
FIGURE 1