Sony XDCAM HD PDW-HD1500 - Manual (Page 123)

123
Maintenance Menu
Chap
te
r 7
Men
u
s
a) A jumbo frame is a frame larger than the maximum 1514 bytes (not
including FCS) of the standard Ethernet frame. Jumbo frames make it
possible to deliver larger payloads per packet. Since fewer packets need to
be routed, packet processing overhead is lower and network throughput is
potentially improved. (Note that this item is enabled only when LINK
SPEED is set to “1000Mbps”. For it to work, all other devices that handle
packets on the network must also support jumbo frames.)
Maintenance menu operations
This section describes the indications in the maintenance
menu and how to change the settings.
To display the maintenance menu
Holding down the PAGE/HOME button and the SHIFT
button, press the MENU button.
The maintenance menu appears on the video monitor
display and the currently-set menu item is displayed in
reverse video.
Meanings of indications on the menu
screen
To change a menu item setting
Carry out the following operations to change the setting.
For information about how to change network settings see
next section “To change network settings”.
M53: DEFAULT GATEWAY
PRESET Set the default gateway.
000.000.000.000
Note
When DHCP is set to “ENABLE”, it is not possible to set the default gateway.
M54: LINK SPEED Set the communications speed.
AUTO, 10Mbps, 100Mbps, 1000Mbps
M55: DUPLEX Set the communications method.
AUTO, Full Duplex, Half Duplex
For how to set the communication method, see “To change network settings” (page 124).
M56: JUMBO FRAME
a) Set the size of jumbo frames.
9014, 4088, OFF(1514)
Note
This value does not include the 4 bytes of the FCS (Frame Check Sequence).
M5: NETWORK: items relating to network settings
Item Setting
On-screen indication Meaning
Right-pointing arrow
(
c) at the right of a
menu item
Pressing the PUSH SET(S.SEL)
knob or the
b/OUT button switches
to the next lower menu level or to a
setting selection screen.
Left-pointing arrow ( C)
at the left of a menu
item
Pressing the PUSH SET(S.SEL)
knob or the
B/IN button switches to
the previous (higher) menu level.
Character string at the
right of a menu item Current setting of the menu item
When shown with a colon (:): the
current setting is the same as
the factory default setting.
When shown with a raised dot
(.): the current setting is
different from the factory
default setting.
An * (asterisk) in a
complete list of settings Factory default setting
On-screen indication Meaning
REC NET
REMOTE LOCAL
VARIABLE KEY INHI
PRE- SET
ON
OFF PB
PHONES LEVEL
SHIFT
DISPLAY
HOME
PAGE
EXPAND
CHAPTER
TOP F REV F FWD END STANDBY REC INHI
PREV NEXT PLAY STOP REC THUMBNAIL
RETURN
PUSH SET(S.SEL)
MENU
RESET
MARK2
MARK1
IN OUT
SHTL/JOG
SUB CLIP
DISC MENU
VAR/JOG
EJECT
ACCESS
CH-1
ALL CH
CH-2
CH-3
CH-4
MENU button
SHIFT button
PAGE/HOME button
Function buttons Arrow buttons
PUSH SET(S.SEL) knob