Sennheiser EW100 G2 - Manual (Page 37)

37
Recommendations and tips
... for the ME 2 and ME 4 clip-on microphones
y To reduce level variations to a minimum when the user turns his or her head
away from the microphone, attach the microphone as centrally as possible.
y To protect the microphone against excessive sweat/moisture, avoid direct
skin contact.
y Attach the microphone carefully and conduct the cable so that noise due to
friction is avoided.
y Always use the ME 4 directional microphone with a windshield and direct
the microphone towards the sound source (e.g. mouth).
... for the ME 3 headmic
y Always use the microphone with a popshield and position the microphone
at the corner of the mouth.
y You can vary the bass reproduction by increasing/decreasing the talking
distance to the microphone.
y Make sure that the sound inlet is directed towards the mouth. The sound
inlet is marked with a little dot.
... for the SK 100 G2 bodypack transmitter
y Make sure that the antenna and the microphone cable do not cross.
y The antenna should hang freely and be at least 1 cm away from the body.
The antenna must not be in direct contact with the skin.
y For best results, make sure that the transmitter sensitivity is correctly
adjusted.
... for the SKM 100 G2 radiomicrophone
y Hold the SKM 100 G2 in the middle of the microphone body. Holding it close
to the sound inlet basket will influence the microphone’s pick-up pattern,
holding it at the lower part of the body will reduce the transmitter’s range.
y You can vary the bass reproduction by increasing/decreasing the talking
distance to the microphone.
y For best results, make sure that the transmitter sensitivity is correctly
adjusted.
... for the EK 100 G2 bodypack receiver
y The antenna should hang freely and be at least 1 cm away from the body.
The antenna must not be in direct contact with the skin.
... for optimum reception
y Transmission range depends to a large extent on location and can vary
from about 10 m to about 150 m. There should be a “free line of sight” bet-
ween transmitting and receiving antennas.
y If, with the EM 100 G2 receiver, reception conditions are unfavourable, you
should use two remote antennas which are connected via antenna cable.
y To avoid overmodulating the receiver, observe a minimum distance of 5 m
between transmitting and receiving antennas.
y Observe a minimum distance of 50 cm between receiving antennas and
metal objects (such as cross members or reinforced-concrete walls).