Sterling Plumbing Bypass Shower Doors 6065 - Manual (Page 7)

4. Install the Wall Jambs
NOTE: When the wall jambs are properly positioned, the slots will be on the bath side of the wall jamb.
The slots should also be positioned away from the wall, closer to the door.
Secure the storage side wall jamb to the wall with three #8-18 x 1-1/2
″ panhead screws.
Secure the second wall jamb to the wall with two #8-18 x 1-1/2 ″ panhead screws located in the
upper and lower installation holes.
Run a #8-18 x 1-1/2
″ screw through a bumper insert, insert the screw in the middle installation hole,
and tighten.
IMPORTANT! Do not apply caulk or sealant to the bottom track at this time.
NOTE: When positioning the bottom track, make sure the track extension is positioned on the storage
column side of the installation.
Position the bottom track assembly on the threshold.
Slide the bottom track assembly to each side until both ends are flush against the wall jambs.
Bottom Track
Wall Jamb
Screw
Screw
Screw
Screw Screw
Bumper Insert
Wall Jamb Fully
Engaged with
Bottom Track
Bottom Track
Track
Extension
Wall Jamb
Bumper
Insert
Slots go toward
the inside of bath.
Storage Side
Wall Jamb
#8-18 x 1-1/2" Screw
Inside of Bath
Outside of Bath
Sterling 7 1035946-2-C