Sterling Plumbing Bypass Shower Doors 6065 - Manual (Page 5)

1. Determine the Installation Configuration
NOTE: Determine the configuration of your installation.
The storage shelves may be mounted on either side of the installation.
2. Locate the Bottom Track
NOTE: Make sure the gap in the bottom track assembly is positioned on the storage column side of the
threshold. If needed, remove the rail and track extension and reinstall them in the opposite end of the
track.
Place the bottom track on the flattest part of the bath/shower ledge with the leg toward the outside
of the shower.
Position the bottom track so there is a 3/4
″ (1.9 cm) equal gap between each wall and the ends of
the bottom track.
Temporarily secure the bottom track to the ledge with masking tape.
Determine Left or Right
Shelving Location.
Space to be approximately
3/4" (1.9 cm) on each end.
Tape to hold
placement of
bottom track.
Storage
Column Side
Bottom Track
Rail
Track Extension
Bottom Track Leg Toward
Outside of Shower
Sterling 5 1035946-2-C