Sanyo DSR-2108 - Manual (Page 78)

Remote Setup
71
b Setting the detection frame
Set the zone where the motion sensor will be active.
1 Set [Motion Zone] to "PARTIAL ZONE".
A button is displayed to the right.
2 Click the button.
The screen for setting the detection frame is displayed.
3 Click (or drag) a grid cell in the desired detection
frame.
The sensor is set in the specified frame.
4 Click [OK].
The contents of the setting are saved and the screen for
setting the detection frame closed.
b Setting the SCHEDULE recording
Set the schedule for the SCHEDULE recording.
1 Click the [Timer Set] button.
The [Schedule] screen is displayed.
2 Select a recording mode button 1 and click it.
The selected recording mode is displayed in colour at
the upper left corner of the schedule 2.
3 Specify the day of the week and time slot, and click
(or drag) the grid cell of the schedule.
Recording is scheduled for the specified time slot.
Multiple recording modes can be combined using the
same procedure.
Memo: To schedule the selected recording mode for all of the
time slots (24 hours) of a day, click the button of the
day of the week.
4 Click [OK].
The contents of the setting are saved and the
[Schedule] screen closed.
1
2
L8HBT_WA(DSR-2116_2108)(GB).book 71 ページ ２００９年５月２７日 水曜日 午後４時５０分