Woodstock W1828 - Manual (Page 17)

Model W1828 (For Machines Mfg. Since 4/11)
-15-
SE
TU
P
Test run your machine to make sure it runs properly and
is ready for regular operation.
The test run consists of verifying the following: 1) The
motor powers up and runs correctly, and 2) the safety
disabling mechanism on the switch works correctly.
If, during the test run, you cannot easily locate the source
of an unusual noise or vibration, stop using the machine
immediately, then review Troubleshooting on Page 25.
If you still cannot remedy a problem, contact our Tech
Support at (360) 734-3482 for assistance.
To test run the machine, do these steps:
1. Make sure you understand the safety instructions
at the beginning of the manual, and verify that the
machine is set up properly.
2. Ensure all tools and objects used during setup are
cleared away from the machine.
3. Verify that the machine is operating correctly by
turning the machine ON.
— When operating correctly, the machine runs
smoothly with little or no vibration or rubbing
noises.
— Investigate and correct strange or unusual noises
or vibrations before operating the machine further.
Always disconnect the machine from power when
investigating or correcting potential problems.
4. Turn the machine OFF.
5. Remove the switch disabling key (Figure 10).
6. Try to start the machine with the paddle switch.
— If the machine does not start, the switch disabling
feature is working as designed.
— If the machine starts, immediately stop the
machine. The switch disabling feature is not
working correctly. Call Tech Support for help.
Test Run
Figure 10. Removing switch key from
paddle switch.
Projectiles thrown from this machine
could cause serious eye injury. Wear
safety glasses to reduce the risk of
injury.