Sharp UX-340LM - Manual (Page 30)

Setting Up and Using OpenLCR
28
1
Place the form with the side you
wrote on face down, and push it
gently into the document feeder of
the fax machine.
READY TO SEND
2
Press the OpenLCR key, the 5 key,
and then the START/MEMORY key.
OpenLCR
START/MEMORY
5
Registering by fax
To register by fax, fill in the Fax
Transmission Test and OpenLCR
Line Activation Form, and then fax
the form as follows:
•
Your fax automatically calls
OpenLCR and sends the form.
After the form is sent, your fax will
automatically receive the rate data.
This lasts one or two minutes.
When downloading is completed,
the display will briefly show
DOWNLOAD OK!! and then revert
to the date and time. Your fax will
print out the registration form to
confirm that it was received.
•
OpenLCR will also program the
date and time and your fax number
in your fax machine.
Registering by phone
To register by phone, follow these
steps:
1
Pick up the handset on the fax
machine.
2
Press the OpenLCR key and then
the 1 key.
1
OpenLCR
3
If the display shows the alternating
messages at right, press the
number keys to enter your fax/
phone number, including the area
code (the number must be 10 digits
long). When finished, press the
START/MEMORY key.
(If the message at right doesn’t
appear, this step is not necessary.)
SET OWN NUMBER
10 DIGITS
START/MEMORY
Enter your
phone number
(with area code)
Important!
Be sure that you enter your correct
area code and fax number. If not,
your fax may not dial the correct
number to connect to OpenLCR.
all_ux340lm.book Page 28 Tuesday, November 28, 2000 3:09 PM