Soho NBG800 - Manual (Page 26)

18 SOHOware ® Secure Cable/DSL Router
step6. Select Obtain an IP address automatically and Obtain DNS server
address automatically. Click OK and go to step 9. If you want to
assign a static IP to a PC, go to step 7
Note: The BroadGuard operates as a DHCP server (it automatically assigns an
IP address to connecting computers) and must be the only DHCP server on
the network
step7. Check Use the following IP address (Figure 23) and enter an IP
address for your PC in the IP Address field. If the PC is to be used as a
DMZ Host, or controlled by Access Control, assign an IP to the PC
from the range 192.168.1.2~192.168.1.11. Enter 255.255.255.0 into the
Subnet Mask field. On the Gateway sheet, enter the BroadGuard’s IP
address into the Default Gateway field (the default value is
192.168.1.1). Click OK
step8. Check Use the following DNS server addresses (Figure 23) and enter a
DNS IP address for your BSP in the Preferred DNS server field. If you
don’t know your BSP’s domain name server IP address, contact your
BSP to get this information
Figure 23. Internet Protocol (TCP/IP Properties-2
step9. Click OK to complete the installation