Woodstock SHOP FOX W1730 - Manual (Page 29)

-27-
SERVICE
W1730 Oscillating Edge Sander
The Model W1730 comes equipped with a puller to
remove the drive roller should it ever become necessary
to do so.
To remove the drive roller, do these steps:
1. Remove the hex nut and lock washer securing the
driver roller to the shaft.
2. Thread the two 1/4-20 x 1-3/4 cap screws on the
puller four turns into the threaded holes in the drive
roller.
3. Thread and tighten the 5/16-18 x 1-1/4 cap screw
into the puller, shown in Figure 39, until the drive
roller is pulled.
4. To re-install, place the drive roller on the shaft, and
thread the lock washer and hex nut onto the shaft
and tighten securely. Note: Do not hammer the drive
roller onto the shaft or you will cause damage to the
shaft.
Removing Drive Roller
Figure 39. Using the drive roller puller.