Sun Microsystems Computer Monitor - Manual (Page 14)

User’s Manual - 4
Copyright(c) 2004, Sun Microsystems, Inc. All rights reserved.
Setup
Connecting Your Monitor
1. Connect the power cord for your monitor to the power port on the back of the monitor.
Plug the power cord for the monitor into a nearby outlet.
2. Using the D-sub (Analog) connector on the video card.
Connect the signal cable to the 15-pin, D-sub connector on the back of your monitor.
3. Using the DVI (Digital) connector on the video card.
Connect the DVI Cable to the DVI Port on the back of your Monitor.
4. Turn on your computer and monitor. If your monitor displays an image, installation is
complete.
If you connect both the D-sub and DVI cables to one computer at the same time, you may get a blank
screen, depending on the type of video card you are using.
If you properly connect your monitor using the DVI connector but get a blank screen, check to see if the
monitor status is set to analog. Press the Source button to have the monitor double-check the input
signal source.
1
3
Rear of monitor
Rear of computer
2