Sun Microsystems Computer Monitor - Manual (Page 13)

User’s Manual - 3
Copyright(c) 2004, Sun Microsystems, Inc. All rights reserved.
Introduction
Rear
1. Power port Connect the power cord for your monitor to the power port on the
back of the monitor.
2. DVI Port Connect the DVI Cable to the DVI Port on the back of your Monitor.
3. Signal port Connect the signal cable to the 15-pin, D-sub connector on the back
of your monitor.
a. Power on/off Switch
Note: See Connecting Your Monitor for further information regarding cable connections.
1 2 3
a