SMC Networks TIGERSWITCH SMC6752AL2 - Manual (Page 254)

C
OMMAND
L
INE
I
NTERFACE
4-14
Line Commands
You can access the onboard configuration program by attaching a VT100
compatible device to the server’s serial port. These commands are used to
set communication parameters for the serial port or Telnet (i.e., a virtual
terminal).
Table 4-5 Line Commands
Command Function Mode Page
line Identifies a specific line for configuration and
starts the line configuration mode GC 4-15
login Enables password checking at login LC 4-16
password Specifies a password on a line LC 4-17
timeout login
response Sets the interval that the system waits for a user
to log into the CLI LC 4-18
exec-timeout Sets the interval that the command interpreter
waits until user input is detected LC 4-19
password-thresh Sets the password intrusion threshold, which
limits the number of failed logon attempts
LC 4-20
silent-time* Sets the amount of time the management
console is inaccessible after the number of
unsuccessful logon attempts exceeds the
threshold set by the password-thresh
command LC 4-21
databits* Sets the number of data bits per character that
are interpreted and generated by hardware LC 4-22
parity* Defines the generation of a parity bit LC 4-23
speed* Sets the terminal baud rate LC 4-23
stopbits* Sets the number of the stop bits transmitted per
byte LC 4-24
disconnect Terminates a line connection PE 4-25
show line Displays a terminal line's parameters NE,
PE 4-25
* These commands only apply to the serial port.