John Deere AC-115 - Manual (Page 11)

Operator’s Manual 11
Assembly
ASSEMBLY
NOTE: For 115 and 165 Models Only
These models are furnished with wheels and a handle.
Some models are furnished with a second handle also.
Wheels, handle(s), and the mounting hardware are found
in the shipping carton.
Tools Needed
• Medium Phillips Screwdriver
• 3/8" Open or Adjustable Wrench
• Hammer
1. Slide axle through wheel support frame. Install wheel spacers
if provided. Install wheels on axle.
IMPORTANT: When installing wheels, point extended
hub of wheels toward wheel support frame (Fig. 1).
2. Place cap nuts on axle ends. Gently tap with hammer
to secure.
3. Place space heater on wheel support frame. Line up
holes on fuel tank flange with holes on wheel support
frame.
4. Place handle(s) on top of fuel tank flange. Insert
screws through handle(s), fuel tank flange, and wheel
support frame. Attach nut, hand tight after each screw
is inserted.
5. After all screws are inserted, tighten nuts firmly.
Wheel Support
Frame
Fuel
Tank
Flange
Cap Nut
Wheel
Nut
Axle Extended
Hub
Air
Inlet
Handle
Hot Air
Outlet
Screw
Wheel Spacer
(If Provided)
Cord Cleat with
Bolts and Nuts
Handle
(Fig. 1)