Integra DTR-7 - Manual (Page 43)

43
Other setup operations
• Using the on-screen display
1. Press the OSD MENU button.
2. Select "Input Selector" and then press the right edge of the
ENTER/Cursor button.
3. Select "IntelliVolume Setup" and then press the right edge
of the ENTER/Cursor button.
The IntelliVolume Setup screen appears. When the cursor is on
"TAPE," you can press the lower edge of the ENTER/Cursor
button to display additional items.
4. Press the upper or lower edge of the ENTER/Cursor button
to select the input source and then press the right or left edge
of the button to select a value
Select a desired adjustment value for each input source. The set-
ting is possible in the range between -12 / +12 dB, in units of
1 dB.
5. Press the center of the ENTER/Cursor button, or press the
EXIT button, to exit the setup mode.
1
2
SP/SYS
SETUP
PRESET/MODE ADJ
PUSH TO ENTER
IntelliVolume setup
The output level of each component or source connected to your
receiver varies, even when the sound volume setting is same. You
must therefore readjust the sound volume by yourself each time you
change the input source, because the same volume setting causes too
loud or too quiet sound. To prevent this inconvenience, you can set a
correction value for each level of input source in advance.
1. Select the source to which you wish to set IntelliVolume by
pressing the corresponding input selector button.
2. Press the SP/SYS SETUP button repeatedly until
“IntelliVolume?” appears. Press the SMART SCAN CON-
TROLLER.
Now you can perform IntelliVolume setup.
3. While listening to playback sound, rotate the SMART
SCAN CONTROLLER to select a desired value.
The setting is possible in the range between -12 / +12 dB,in units
of 1 dB.
Press the SMART SCAN CONTROLLER.
* IntelliVolume Setup *
CD : 0dB
PHONO : 0dB
FM : 0dB
AM : 0dB
TAPE : 0dB
Volume display method setup
You have the option of displaying your volume settings either of
two ways:
• ABSOLUTE — on a scale of MIN (0: no sound) to MAX (80:
maximum volume);
or
• RELATIVE — on a scale which is measured “plus or minus,”
relative to the calibrated reference volume.
With either settings, the volume level changes in the same incre-
ment.
ABSOLUTE: MIN, 1, 2, 3, 4, ......., 77, 78, 79, MAX
RELATEVE: –
∞
, –61, –60, –59, ......., +16, +17, +18 (dB)
1. Press the SP/SYS SETUP button repeatedly until “Volume
Display?” appears.
2. Press the SMART SCAN CONTROLLER.
Now you can change the sound volume display method.
3. Rotate the SMART SCAN CONTROLLER to select
“Absolute” or “Relative.”
4. Press the SMART SCAN CONTROLLER.
PRESET/MODE ADJ
PUSH TO ENTER
3
SP/SYS
SETUP
3
1
PRESET/MODE ADJ
PUSH TO ENTER
2
VIDEO-1 VIDEO-2 VIDEO-3 VIDEO-4 DVD FM AM PHONO C D TAPE
PRESET/MODE ADJ
PUSH TO ENTER
PRESET/MODE ADJ
PUSH TO ENTER
4 PRESET/MODE ADJ
PUSH TO ENTER
SPEAKERS
A
DSP
SPEAKERS
A
DSP
SPEAKERS
A
DSP
SPEAKERS
A
STEREO
AUTO
SPEAKERS
A
db
AUTO
STEREO