Inter-Tel INT1100 - Manual (Page 35)

[ 35 ]
CALLER ID
C A L L E R I D
• You cannot make a call
from the Caller ID list if
your phone is connected
to a private branch
exchange (PBX).
• When a long distance
call has been set, “ 1 ”
appears in the display.
• If a call comes in via a
telephone system that
does not offer Caller ID
service, no information
is stored.
Calling a party from the Caller ID list
From Standby mode
1) Press call id/ . The summary screen appears. The screen shows the
number of new messages and the total number of messages.
2) Use the number keypad (2-9 and 0), +, or - to view the Caller ID message list.
3) Press talk/flash or spkr. The displayed phone number
dials automatically.
From Talk mode
1) Press talk/flash.
2) Press call id/ . The summary screen appears.
3) View the Caller ID message you want to dial.
4) Press select/ch. The displayed phone number will be dialed.
Long Distance calls and Area Code Setting/Cancellation
While the present Caller ID information is displayed, pressing /tone will place or remove
the prefix “ 1 ” in the display to set the call for a long distance call, or pressing # will set or
cancel an area code. (See page 16.)
Storing Caller ID messages in the Phonebook/RocketDial
Messages shown in the Caller ID list can be stored in the phonebook. Using the incoming
call information (i.e., Caller ID list), the phone number and name of the party on the Caller
ID list can be stored in memory.
1) When the phone is in the standby mode, while the incoming Caller
ID information is displayed, press /RocketDial/ .
2) Press + or - to choose “ Store in PB? ” (Phonebook locations) or
“ Store in SD? ” (RocketDial location). To cancel Storing, select
“ Cancel ”.
Using the Caller ID Message List
Connecting
8002971023
INT1100 Manual-5.0.qxd 1/29/04 12:09 AM Page 35 Bob's Garage: New Backup: Clients:CoastlineCreative:Clients:Int