Inter-Tel INT1100 - Manual (Page 14)

[ 14 ] G E T T I N G S T A R T E D
Entering Your Area Code
If you enter a 3-digit area code number in the “ Area Code ” option, your local area code does
not appear in Caller ID messages. For calls received from outside your local area code, you will
see a full 10-digit number.
1) When the phone is in the standby mode, press menu/mute.
2) Press + or - to move the pointer to “ Caller ID Setup ”,
then press select/ch.
3) Press + or - to move the pointer to “ Area Code ”,
then press select/ch.
4) Use the number keypad (0 to 9) to enter a 3-digit
area code.
5) Press select/ch, and you will hear a confirmation tone.
6) Press end to exit.
• If your calling area
requires 10-digit
dialing, do not program
this option.
• When the area code has
already been stored in
memory, the stored area
code will be displayed.
To change it, press
xfer/del three times.
Then enter the new
area code. Or you can
use
/RocketDial/
or call id/ to move
the cursor and edit the
area code.
INT1100 Manual-5.0.qxd 1/29/04 12:09 AM Page 14 Bob's Garage: New Backup: Clients:CoastlineCreative:Clients:Int