Icom COMMUNICATIONS RECEIVER IC-R3 - Manual (Page 20)

■ Memory bank selection
The receiver has 400 memory channels in 8 banks (A–H) for
storage of often-used frequencies.
q Select memory mode with [V/M].
w Rotate [DIAL] while pushing [FUNC] to select the desired
memory banks.
e Rotate [DIAL] to select the desired memory channel.
■ Memory clear
Unwanted memory channels can be cleared (erased). Before
clearing a memory channel, make sure it is no longer needed
as cleared memories cannot be recalled.
q Select memory mode with [V/M].
w Set the memory channel to be cleared with [DIAL].
• Rotate [DIAL] while pushing [FUNC] to select a memory bank
(A–H) or programmed scan edge channel.
e Select VFO mode with [V/M] and push [V/M] for 1 sec. to
indicate the selected memory channel.
• Do not hold [V/M] for more than 2 sec., otherwise the selected
memory channel will be overwritten.
r Push [FUNC] + [V/M] for 2 sec. to clear.
• 3 beeps sound, then the frequency is cleared.
t Push [MODE] to return to VFO mode.
FM FM FM
Memory bank A Memory bank G Memory bank H
16
5
MEMORY CHANNELS
FM FM FM
S1 3 5 7 9
VOL
FM
146.340.000
M:A03
TS 15.0
S1 3 5 7 9
VOL
FM
146.010.000
TS 15.0
S1 3 5 7 9
VOL
FM
146.340.000
M:A03
TS 15.0
S1 3 5 7 9
VOL
. .
M:A03
TS .
MODE SET
Select memory
channel
for 2 sec.
+
for 1 sec.
V/M SKIP V/M SKIP
V/M SKIP V/M SKIP
FUNC
[EXAMPLE]: Clearing memory channel 3 (memory bank A).