Insignia IS-CM100751 - Manual (Page 11)

9
IS-CM100751 19-inch Color Monitor
www.Insignia-Products.com
Using Self Diagnosis
If the monitor does not display, press any key and the Self Diagnosis screen
opens. Self Diagnosis checks the status of the monitor and determines
whether there is a valid signal.
The No Signal screen opens when the VGA
connector is not connected to a computer or when
the monitor is in DPMS mode.
The Out of Range screen opens when the applied
frequency is under or over the normal frequency
range.
Normal range
H: 30-95 KHz
V: 50-160 Hz
T.Pin Corner Adjust the pin corner top when the top sides of
the screen are bowed.
B.Pin Corner Adjust the pin corner bottom when the bottom
sides of the screen are bowed.
Rotation Adjust the rotation when the screen is tilted left
or right.
Degauss Keep the monitor free from unwanted
magnetism that can result in color impurity.
Status Display horizontal and vertical frequency and
polarity.
Signal Level Change the signal voltage if images run on the
monitor. Video input signal voltage varies
between video cards. The factory default is
0.7 V.
Recall Reset the screen to the factory settings.
Color Test Display an RGB color bar to determine if the
screen color is expressed normally.
Icon Control Function
NO SIGNAL
OUT OF RANGE
HF: 30-95 KHz
V: 50-160 Hz
PC DISPLAY SETTINGS
CORRECT?
IS-CM100751_combined.fm Page 9 Tuesday, April 12, 2005 10:14 AM