Printing a configuration test, Printing a configuration test page – Intermec Mobile PB3 User Manual
Page 21
PB3 Mobile Printer User’s Guide
11
Printing a Configuration Test Page
Once the battery is charged and paper is loaded, you can print a
configuration test page. Use this information for reference when
installing the PB3 and to verify correct printer operation. If you
cannot print the test page, see
To print a test page
1
Make sure the printer is off before you begin.
2
Press and hold the
Feed button.
3
Press the
Power button once to turn on the printer. When the
printer starts printing the test page, release the
Feed button.
4
To stop or cancel printing the test page, press either the
Power or
Feed button.
Note: If you are using the AC adapter/charger as a power source, the
printer will not print unless a battery is installed.