Intermec EASYCODER PD4 - Manual (Page 60)

50 Intermec EasyCoder PD4—User’s Guide
Chapter 7—Troubleshooting
Entering the Dump Mode
In the Dump Mode, the printer prints all received ASCII characters
including control characters (ASCII 00-31 decimal). There is automatic
line-wrapping and if a label becomes completely filled, the dump contin-
ues on a new label. This facility is useful for debugging.
Enter the Dump Mode like this:
1
Switch off the power to the printer.
2 Press and hold the Feed key while you switch on the power again.
3 The Feed key must be pressed for more than 2 seconds after power up
(else a test label will be printed).
4 When the printer is in Dump Mode, this message will be displayed
provided the printer is fitted with an optional display:
In the Dump Mode, you can reset the printer to its default setup values
by pressing the Cancel key for 3 seconds or more.
To exit the Dump Mode and enter the Direct Mode, tap the Feed key.