Replacing the diskette drive, Replacing the keyboard, Replacing – IBM THINKCENTRE 8123 User Manual
Page 38: Diskette, Drive, Keyboard
Replacing
the
diskette
drive
Attention:
Do
not
remove
the
computer
cover
or
attempt
any
repair
before
reading
the
“Important
safety
information”
in
the
Quick
Reference
that
was
included
with
your
computer
or
in
the
Hardware
Maintenance
Manual
(HMM)
for
the
computer.
To
obtain
copies
of
the
Quick
Reference
or
HMM,
go
to
http://www.ibm.com/pc/support.
1.
Remove
the
computer
cover.
See
2.
Remove
the
front
bezel.
See
Note:
For
this
procedure,
it
helps
to
lay
the
computer
on
its
side.
3.
Disconnect
the
signal
and
power
cables
from
the
rear
of
the
diskette
drive.
4.
Release
the
diskette
drive
by
pressing
on
the
blue
retainer
lever
at
the
side
of
the
drive
bay
and
slide
it
out
the
front
of
the
computer.
5.
Remove
the
retainer
bracket
from
the
failing
drive
and
install
it
on
the
new
drive.
6.
Slide
the
new
diskette
drive
into
the
lower
drive
cage
until
it
snaps
into
position.
7.
Reconnect
the
signal
and
power
cables
to
the
drive.
8.
To
install
the
bezel,
align
the
tabs
on
the
bottom
of
the
bezel
with
the
corresponding
holes
in
the
chassis.
Pivot
the
bezel
until
it
snaps
into
position
at
the
bottom
and
top
of
the
chassis.
9.
Go
to
Replacing
the
keyboard
Attention:
Do
not
remove
the
computer
cover
or
attempt
any
repair
before
reading
the
“Important
safety
information”
in
the
Quick
Reference
that
was
included
with
your
computer
or
in
the
Hardware
Maintenance
Manual
(HMM)
for
the
computer.
To
obtain
copies
of
the
Quick
Reference
or
HMM,
go
to
http://www.ibm.com/pc/support.
30
Hardware
Replacement
Guide