Icom COMMUNICATION RECEIVER IC PCR100 - Manual (Page 12)

8
2
PANEL DESCRIPTION
@4
KEYPAD [0]–[9], [•], [CE] (p. 17)
➥ [0] to [9] are used to input a receive frequency or mem-
ory channel directly.
➥ [•] (Decimal) button is used to set the MHz digit when in-
putting a frequency.
➥ [CE] (Clear) button is used to clear mistakes while in-
putting a receive frequency or memory channel.
@5 IF FILTER BUTTONS [NAR]/[WID] (p. 20)
Push to change the IF filter in use. The [WID] button se-
lects a wider filter, the [NAR] button selects a narrower fil-
ter.
• Usable IF filters vary according to receive mode.
@6 SCAN STOP BUTTON [STOP] (p. 26)
Push to cancel scan operation.
@7 PROGRAMMED SCAN BUTTON [PROG] (p. 27)
Push to start/stop programmed scan.
• “PROG” flashes while scanning.
@8 SPAN +/– BUTTONS [SPAN+]/[SPAN–] (p. 34)
Push to select one of four levels for the band scope fre-
quency span.
@9 AUTO MEMORY WRITE SCAN BUTTON [AUTO] (p. 29)
Push to start/stop auto memory write scan.
• “AUTO” flashes while scanning.
@4
@5 @6 @7 @8 @9 #1 #2 #3 #6 #7 #4 #5 #0