Invacare Compressor User Manual
Page 24

SECTION 5—COMPRESSOR OPERATION
HomeFill
®
Compressor
24
Part No 1100873
4. Momentarily push DOWN on the outer ring (sleeve) of the
connector fillport until GREEN dots are visible to reset the
connector (FIGURE 5.1).
NOTE: If the outer ring (sleeve) is in the UP position
(GREEN dots not visible), the connector fillport will not be
able to accept the cylinder fillport. Pushing DOWN
momentarily will reset the connector fillport (GREEN dots
visible) to accept the cylinder fillport.
FIGURE 5.1 Resetting Connector Fillport
5. Grasp the cylinder in the area behind the cylinder fillport
(FIGURE 5.2).
6. Position the cylinder in the compressor cradle (FIGURE 5.2).
7. Align the cylinder fillport with the connector fillport
(FIGURE 5.2).
8. Pull UP on the outer ring (sleeve) of the connector fillport
while pushing DOWN on the cylinder to couple the cylinder
fillport into the connector fillport (FIGURE 5.2).
NOTE: The cylinder is properly connected when an audible “click” is
heard.
Connector Fillport
Outer Ring (Sleeve)
PUSH
DOWN
GREEN Dots
BEFORE
COUPLING
CYLINDER
PUSH DOWN
ON SLEEVE
UNTIL
GREEN DOTS
ARE VISIBLE