Transporting the compressor ƽ warning, Caution, Installing the power cord – Invacare Compressor User Manual

Page 17

SECTION 3—INITIAL SETUP

Part No 1100873

HomeFill

Compressor

Transporting the Compressor

ƽ WARNING

NEVER transport a compressor with a cylinder connected to or
stored on the compressor, otherwise injury or damage can occur.

CAUTION

When transporting the compressor, be careful not to bump the
compressor or the connectors into obstacles. Otherwise, damage
to the compressor may occur.

NOTE: For this procedure, refer to FIGURE 3.1.

1. There are two methods to

safely transport the
compressor:

• One Hand ‐ Grasp the

hand grip at the
bottom rear of the
compressor.

• Two Hands ‐ Grasp the

hand grips on the sides
of compressor.

FIGURE 3.1 Transporting the

Compressor

Installing the Power Cord

NOTE: For this procedure, refer to FIGURE 3.2 on page 18.

1. Choose a proper location. Refer to Choosing a location on

page 16.

2. Make sure the power switch is in the Off (O) position

3. Plug the power cord into the electric connector in the back of

the compressor.

4. Plug the opposite end of the power cord into the wall outlet.

Hand Grip