Icom DSC CONTROLLER DS-100 - Manual (Page 25)

5
21
CONNECTION AND INSTALLATIONS
■ Rear panel description
q
CONNECTION CABLE
Connets to the IC-M501EURO rear DSC controller recep-
tacle.
w RECEIVE ANTENNA CONNECTOR
Connects a marine VHF receiving antenna with a PL-259
plug for emergency frequency signal receiving.
• Receiving frequency : 156.525 MHz
• Keep the emergency frequency signal receiving antenn
away from the marine VHF antenna to avoid interference
from the emitted RF signal.
e
CLONE RECEPTACLE
For dealer use only.
r GPS RECEIVER CONNECTOR
Connects a GPS receiver (NMEA0183 ver.2.0) for sending
position data without manual input.
t ANTENNA CONNECTOR (IC-M501EURO)*
Connects a marine VHF antenna with a PL-259 connector
to the transceiver.
y EXTERNAL SPEAKER RECEPTACLE (IC-M501EURO)*
Connects to an external speaker.
u DC POWER CONNECTOR (IC-M501EURO)*
Connects the DC power cable supplied with IC-
M501EURO, from this connector to an external 12 V DC
power source.
*Refer to the IC-M501EURO instruction manual.
■ Supplied accessories
q Nob bolt (2040 knob bolt) ............................................... 2
w Mounting bracket (2345 Mobile bracket) ......................... 1
e Spring washers (M 5 ) .................................................... 2
r Self-tapping screws (A05 x 20)........................................ 2
t Flat washers (M 5)........................................................... 2
y Label (2349 CAUTION seal-R)........................................ 1