Insignia NS-R2000 User Manual
Page 13
11
Insignia NS-R2000 Stereo Receiver
www.insignia-products.com
3 Select a preset number between 1 and 30,
then press the MEMORY button.
4 Repeat this procedure to memorize
additional stations.
Tuning to preset stations
To tune to a preset station:
1 Select the tuner as the input source.
2 Press T/P MODE to select the preset mode.
PRESETS lights up.
3 Press the PRESET
/
buttons on the
receiver.
-OR-
Enter the preset number using the numeric
keypad.
Scanning preset stations in sequence
To scan preset stations:
1 Press the PRESETS button on the remote
control.
The receiver starts scanning the stations in
the preset sequence. Each station is
sampled for five seconds.
2 Press the PRESETS button again to stop
scanning.
Notes
•
When using the numeric keypad on the remote
control, press the number you want. If your
number is greater than nine, enter the first digit,
then enter the second digit within two seconds.
•
The station has been stored in memory. When
using the numeric keypad, the station is stored
automatically without pressing the MEMORY
button.
•
A stored frequency is erased from memory by
storing another frequency in its place.
•
If MEM goes off, start again from step 2.
OR
OR
Notes
When using the numeric keypad on the remote
control, press the number you want. If your
number is greater than nine, enter the first digit,
then enter the second digit within two seconds.
OR
OR