Moxa Technologies NPort 5600 - Manual (Page 38)

NPort 5600 Series User’s Manual Configuring NPort Administrator
5-8
IP Address Report
When NPort 5600 series products are used in a dynamic IP environment, users must spend more
time with IP management tasks. For example, if NPort works as a server (TCP or UDP), then the
host, which acts as a client, must know the IP address of the server. If the DHCP server assigns a
new IP address to NPort, the host must have some way of determining NPort’s new IP address.
NPort 5000 series products help out by periodically reporting their IP address to the IP location
server, in case the dynamic IP has changed. The parameters shown below are used to configure the
Auto IP report function. There are two ways to develop an “Auto IP report Server” to receive
NPort’s Auto IP report.
1. Use NPort Administrator’s IP Address Report function.
2. “Auto IP report protocol,” which can automatically receive the Auto IP report on a regular
basis, is also available to help you develop your own software. Refer to Appendix E for the
“Auto IP report protocol”.
Auto report to IP
Setting Factory Default Necessity
E.g., 192.168.1.1
(IP addresses of the form x.x.x.0 and
x.x.x.255 are invalid.)
None Optional
Reports generated by the Auto report function will be sent automatically to this IP address.
Auto report to TCP port
Setting Factory Default Necessity
E.g., 4001 None Optional
Auto report period
Setting Factory Default Necessity
Time interval (in seconds) 10 Optional