Marantz LC1500 - Manual (Page 13)

13
CONNECTION
206-3652
Connecting antenna
* To get better picture quality, adjust the direction of antenna.
●
In case of wall antenna socket in apartment houses, connect the antenna cable as shown below.
(Use the correct type of antenna cable to the type of wall antenna socket.)
DC 12V
ANT IN
+ 75 Ω
PC/DTV INPUT C
wall connecting port Apartments
antenna input port
bronze wire
Turn clock arise to
tighten.
antenna
converter
300 Ω flat cable
75 Ω round cable
● This type of antenna is usually used at common private houses.
DC 12V
ANT IN
+ 75 Ω
PC/DTV INPUT C
DC 12V
ANT IN
+ 75 Ω
PC/DTV INPUT C
UHF
antenna
VHF antenna
antenna input port
bronze wire
Turn clock arise to
tighten.
antenna
converter
300 Ω flat cable
75 Ω round cable
* In case of 75
Ω
round cable, insert the bronze wire and then tighten the connecting nut.
And in case of 300
Ω
flat cable, connect the twisted wire to the antenna converter and
then connect the converter to the antenna input port.
* When using 75
Ω
round cable, do not bend bronze. It may cause poor picture quality.
* In poor signal area, you can get better
picture quality if you install the anten-
na like the figure as shown right.
* If an antenna is divided to two TV
sets, use “signal divider” for connect-
ing.
signal
amplifier
UHF VHF
Private house
Connecting to w Connecting to w all antenna soc all antenna soc k k et et
Connecting to outdoor antenna Connecting to outdoor antenna