Marantz VP8100 - Manual (Page 20)

16
ADDITIONAL INFORMATION
ENGLISH
CAUTION:
• Do not touch the lamp and the lamp unit. It will be extremely
hot. Allow at least one hour for the lamp to cool down before
handling.
• Do not loosen any screws except for those mentioned below.
• The lamp may break if handled improperly.
• Do not use a lamp housing other than a Marantz
replacement lamp unit.
WARNING:
• The lamp itself may get hot. Be careful when handling.
1. Press the POWER key to turn the projector off.
2. Unplug the AC power cord.
3. Wait at least one hour for the lamp and lamp unit to cool
down.
4. Turn the projector upside down carefully.
(Read the caution and warning labels on the lamp cover.)
5. Loosen the lamp cover securing screw.
6. Remove the lamp cover.
7. Loosen the three lamp housing screws.
(This projector has a safety switch.)
8. Hold the handle then pull the lamp unit upward to remove
it.
9. Install the new lamp unit.
10. Secure the lamp unit with the three screws.
11. Replace the lamp cover and secure it with a screw driver.
If the lens becomes dirty or smudged, clean it with a soft dry
cloth. Do not use a dampcloth, detergent solution, or thinner. It
may remain as stains. Use optical lens cleaners only which are
approved for eyeglasses or cameras.
When replacement parts are required, be sure to inform only a
Marantz authorized service center. Only the use of
replacement parts specified by Marantz, whose features are
equivalent to the original parts, is allowed. Unauthorized
substitutions may result in fire, electric shock, or other hazards.
Otherwise the warranty may not be guaranteed.
{ Lamp Unit: LU8000VP
{ Ceiling Mount KIT: RM8000VP
CAUTION:
• For ceiling installation, consult with the Marantz dealer.
MAINTENANCE
Replacing the Lamp Unit Cleaning the lens
Replacement parts
Optional accessories