Marantz VP8100 - Manual (Page 16)

12
SET UP PROCEDURES
ENGLISH
1. Connect the supplied AC power cord.
The STANDBY indicator will light in green and the
projector goes into the standby mode.
2. Press the POWER ON key on the remote controller or the
POWER key on the projector.
The POWER key lights in green.
3. Switch on the equipment connected to the projector. Press
the INPUT SELECT key on the projector or the
COMPONENT key, S-VIDEO key, VIDEO key, or RGB key
on the remote controller.
4. Press the OSD key twice on the remote controller to
display the FOCUS PATTERN and turn the Focus ring to
make an adjustment. Adjust the focus for the sharpest
image possible to obtain, using the built-in focus pattern.
Press the OSD key again to clear the pattern.
5. Turn the Zoom ring to adjust the size of the image. The
image should fill the screen vertically with normal 4:3
aspect ratio material. If the user uses a 16:9 screen, the
image will fill the screen horizontally. The use of 4:3 video
source will leave black stripes on the left and right sides in
the 16:9 screen. This is normal.
1. Press the STANDBY key on the remote controller or the
POWER key on the projector.
2. The fan continues to run for a while to reduce internal heat.
The POWER key flashes green and no key will be effective.
After sufficient cooling has been provided, the STANDBY
indicator lights in green.
INITIAL SET UP TO TURN OFF THE POWER