Multi-Tech Systems FR111 - Manual (Page 47)

47
Enter the number that corresponds to the DLCI for your trunk. A
two-digit number can be entered and the zeros will proceed the
digits. The DLCI is supplied by your network service provider at
the time the trunk was provisioned.
When you have entered your DLCI, the Trunk Configuration menu
is displayed.
8 From the Trunk Configuration menu, enter option 5 Committed
Info Rate (CIR) and the CIR menu is displayed.
Enter the CIR (Committed Information Rate), in
units of 1000 (1K). Valid values are between 0K
and 128K. The CIR should be equal to or less
than the Trunk access rate.
x - Enter Number, or
P - Previous Menu
Selection : _
Enter the number that corresponds to the CIR in units of 1K for
your trunk. The CIR range is from 0 to 128K and should be equal
to or less than the trunk access rate which can not exceed 56K.
The CIR is supplied by your network service provider at the time
the trunk was provisioned.
When you have entered your CIR, the Trunk Configuration menu
is displayed.
9 From the Trunk Configuration menu, enter option 6 Excess Burst
Rate (Be) and the Be menu is displayed.
Enter the Be (excess Burst Rate), in units of 1000
(1K). Valid values are between 0K and 128K. The
sum of Be + CIR should be equal to or less than
the Trunk access rate.
x - Enter Number, or
P - Previous Menu
Selection : _
Enter the number that corresponds to the Be in units of 1K for
your trunk. The Be range is from 0 to 128K and the sum of Be
plus CIR should be equal to or less than the trunk access rate.