Multi-Tech Systems Hub User Manual
User guide
Table of contents
Document Outline
- Contents
- System Overview
- Product Overview
- RASExpress
- Documentation Set Overview
- Technical Specifications
- Chassis
- Power Supply
- Dimensions
- Environmental
- Chapter 2 - Installing Your CommPlete 4000
- Unpacking
- Safety Warnings
- Rack Mounting
- Cable Connections
- SBC Board Cabling
- ISI Board Cabling
- Serial Card Upgrades
- Powering Up
- Chapter 3 - Getting Started with RASExpress
- What you need to start
- Accessing RASExpress
- Method A. Do All Configuration using Terminal or Auxiliary PC
- Method B. Start Configuration with Terminal, Finish Configuration on Client PC
- Chapter 4 - Hardware removal/Replacement
- Disconnecting Cables and Removal from Enclosure
- Card Cage Removal/Replacement
- Board Removal and Replacement
- Removing SBC Board
- Removing ISI Boards
- Hard Disk Drive Removal/Replacement
- Floppy Disk Drive Removal/Replacement
- CDROM Removal/Replacement
- Power Supply Removal/Replacement
- Chapter 5 - Troubleshooting
- Troubleshooting
- Diagnostic Tests
- Chapter 6 - Service, Warranty, and
- Technical Support
- Limited Warranty
- Addendum for North American Products
- Addendum for International Products
- Out of Warranty Repair Costs
- On-line Warranty Registration
- Technical Support
- Recording CommPlete 4000 Information
- Contacting Technical Support
- Service
- Ordering Accessories
- Appendices
- Appendix A-Back Panel Connector Pinouts
- Appendix B-Regulatory Information
- FCC Regulations for Telephone Line Interconnection
- Canadian Limitations Notice
- Compliance with BABT Requirements
- European Low Voltage Directive
- Compliance with BS6305 Clause 6.2, BS6320 Clause 7.2, and BABT/SITS/82/005S/D
- Compliance with BS6789: Section 3.1 and Part 2
- Compliance with BS6328 Part 1
- EMC, Safety, and Terminal Directive Compliance