MITSUBISHI ELECTRIC APRICOT 340 - Manual (Page 109)

I n s i d e t h e S y s t e m U n i t
A/8 APRICOT 340 OWNER’S HANDBOOK
Processor speed selection
These settings need to be changed after a Pentium processor
upgrade. They must not be changed otherwise.
Processor speed Jumper block SW1
FS1 FS0 BF BF1 ISA
Pentium 75 MHz 1-2 3-4
Pentium 90 MHz 3-4 9-10
Pentium 100 MHz 1-2 9-10
Pentium 120 MHz 3-4 5-6 9-10
Pentium 133 MHz 1-2 5-6 9-10
Pentium 150 MHz 3-4 5-6 7-8 9-10
Pentium 166 MHz 1-2 5-6 7-8 9-10
Disabling the on-board video controller
You may need to disable the motherboard EVGA video controller
and video BIOS if you add a video adapter expansion card (check
the documentation that came with the card to make sure). You do
this by removing the jumper from PL22, the VESA options jumper
block.
On-board EVGA PL22
Enabled (default) 1-2
Disabled Open